sketch the form of the output signal when T = 2000 K.

A thermocouple has an e.m.f. of 5 mV when the hot junction is at 100 °C and the cold junction is at 0 °C. A thermopile consisting of 25 such thermocouples in series is used as a detector in a chopped, broadband pyrometer. When unchopped the power in the beam of radiation incident on the hot junction of the thermopile is given by 7.5T 4 pW, where T K is the temperature of the distant target. The beam is chopped by a semicircular disc rotating at 6000 r.p.m. The reference junction of the thermopile is at the temperature of the pyrometer

enclosure. Assuming the thermocouples are linear and the detector data given below, sketch the form of the output signal when T = 2000 K.

 

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….