Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze bushing with a transverse load of 1 000 N for conditions of both poor and good lubrication. If the bushing has l / d = 0.5 and a clearance ratio of 0.001, define the lubricant viscosity in microreyn (μreyn) needed to obtain good lubrication.

2.       Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, O= 30, ISO VG 220 oil at 200°F.

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Specify bearing number, bore, OD, width (all in mm) and the basic dynamic load rating of the bearing.

Figure P11-5 shows a stepped shaft supported by two 6300-series bearings. Two gears with equal and opposite torque are keyed to the shaft as shown. The load on each gear….