Find the forces acting on each of the 4 cap screws due to this fluctuating loading and choose a suitable cap screw diameter, length, and preload that will give a minimum safety factor of 1.5 for any possible mode of failure for N = 5E8 cycles.‡

(See also Problem 6-34 on p. 412.) The bracket in Figure P15-2 is fastened to the wall by 4 cap screws equispaced on a 10-cm-dia bolt circle and arranged as shown. The bracket is subjected to a sinusoidal force-time function with Fmax and Fmin = 0, where and the beam’s other data are given in the row(s) assigned from Table P15-1. Find the forces acting on each of the 4 cap screws due to this fluctuating loading and choose a suitable cap screw diameter, length, and preload that will give a minimum safety factor of 1.5 for any possible mode of failure for = 5E8 cycles.‡

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….