Find and graph the magnitudes of the CTFTs of the responses of both types of rectifiers (either form).

In electronics, one of the first circuits studied is the rectifier. There are two forms, the half-wave rectifier and the full-wave rectifier. The half-wave rectifier cuts off half of an excitation sinusoid and leaves the other half intact. The full-wave rectifier reverses the polarity of half of the excitation sinusoid and leaves the other half intact. Let the excitation sinusoid be a typical household voltage, 120 Vrms at 60 Hz, and let both types of rectifiers alter the negative half of the sinusoid while leaving the positive half unchanged. Find and graph the magnitudes of the CTFTs of the responses of both types of rectifiers (either form).

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….