Determine the pitch cone angles, pitch diameters, and gear forces if the 20°-pressure-angle pinion has 16 teeth of pd = 7, and the transmitted power is 3 hp at 600 pinion rpm.

1.       A 90° straight-bevel gearset is needed to give a 9:1 reduction. Determine the pitch cone angles, pitch diameters, and gear forces if the 25°-pressure-angle pinion has 14 teeth of p= 6, and the transmitted power is 746 W at 1 000 pinion rpm.

2.       A 90° straight-bevel gearset is needed to give a 4.5:1 reduction. Determine the pitch cone angles, pitch diameters, and gear forces if the 20°-pressure-angle pinion has 18 teeth of pd = 5, and the transmitted power is 7 460 W at 800 pinion rpm.

3.       A 90° spiral-bevel gearset is needed to give a 5:1 reduction. Determine the pitch cone angles, pitch diameters, and gear forces if the 20°-pressure-angle pinion has 16 teeth of pd = 7, and the transmitted power is 3 hp at 600 pinion rpm.

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….