Design a helical compression spring for a static load of 45 lb at a deflection of 1.25 in with a safety factor of 2.5.

An overhung diving board is shown in Figure P14-1a. A 100-kg person is standing on the free end in the center of its width. Assume cross-sectional dimensions of 305 mm X 32 mm and a material = 10.3 GPa. What are the spring rate and fundamental natural frequency of the diver-board combination?

 Design a helical compression spring for a static load of 45 lb at a deflection of 1.25 in with a safety factor of 2.5. Use = 7.5. Specify all parameters necessary to manufacture the spring.

find the cost of your paper

design suitable bearings to support the load for at least 5E8 cycles at 1 200 rpm using deepgroove ball bearings.

The shaft shown in Figure P11-4 was designed in Problem 10-19. For the data in row (a) of Table P11-1, and the corresponding diameter of shaft found in Problem 10-19,….

Find the minimum film thickness for a long bearing with the following data: 30-mm dia, 130 mm long, 0.0015 clearance ratio, 1 500 rpm, ISO VG 100 oil at 200°F, and supporting a load of 7 kN.

1.       A paper machine processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50-m OD X 22-cm ID X 3.23-m long and is on a simply supported, 22-cm OD, steel….

Find the minimum film thickness for a bearing with these data: 30-mm dia, 25 mm long, 0.0015 clearance ratio, 1 500 rpm, ON = 30, ISO VG 220 oil at 200°F.

1.       Problem 7-12 estimated the volume of adhesive wear to expect from a steel shaft of 40 mm dia rotating at 250 rpm for 10 years in a plain bronze….