Describe the material properties that have an effect on the relative position of the curves shown in Fig. 7.19.

Describe the material properties that have an effect on the relative position of the curves

 

shown in Fig. 7.19. Observing curves (a) and (c) in Fig. 7.19 on p. 364, note that the former is annealed and the latter is heat treated. Since these are all aluminum alloys and, thus, have the same elastic modulus, the difference in their springback is directly attributable to the difference in their yield stress. Likewise, comparing curves (b), (d), and (e), note that they are all stainless steels and, thus, have basically the same elastic modulus. However, as the amount of cold

work increases (from annealed to half-hard condition), the yield stress increases significantly

because austenitic stainless steels have a high n value (see Table 2.3 on p. 37). Note that these

comparisons are based on the same R/T ratio.

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….