Calculate the RMS values of a sinusoidal alternating voltage applied to the Y plates of a CRO if it gives the following vertical lengths of trace, the Y amplifier control setting for each display being shown after the trace length

1. Calculate the RMS values of a sinusoidal alternating voltage applied to the Y plates of a CRO if it gives the following vertical lengths of trace, the Y amplifier control setting for each display being shown after the trace length

 

(a) 5 cm, 10 V/cm

(b) 9 cm, 50 V/cm

(c) 4 cm, 100 V/cm.

2. The current in a load is displayed on a CRO by passing it through a 1.5 resistor and applying the PD across the resistor to the Y amplifier of the CRO. The peak-to-peak amplitude of the display is 7.5 cm when the amplifier setting is 200 mV/cm. Assuming the current wave-shape to be sinusoidal, calculate the RMS value of the current.

find the cost of your paper

Sketch the load characteristics, terminal voltage/load current, of the following types of DC generator

1. (a) Sketch the load characteristics, terminal voltage/load current, of the following types of DC generator: (i) series-connected, (ii) shunt-connected and (iii) compound-connected.   (b) State one purpose for which….

what happens if the resistance in series with the shunt field of a DC motor is increased in value

1. Sparking at the trailing edges of the brushes in a DC machine is usually prevented by fitting   (a) copper gauze brushes (b) a compensating winding (c) a compound….

Calculate the synchronous speed of a 10-pole three-phase machine connected to a 50 Hz supply.

1. The generator characteristic shown in Figure 9.28 is for a   (a) shunt machine (b) series machine (c) differentially compounded machine (d) cumulatively compounded machine 2.The speed of a….