Calculate an accurate value for the differential pressure developed across the chosen Venturi, at maximum flow rate.

A Venturi is to be used to measure the flow rate of water in a pipe of diameter D = 0.20 m. The maximum flow rate of water is 1.5 × 103 m3 h−1, density is 103 kg m−3, and viscosity is 10−3 Pa s. Venturis with throat diameters of 0.10 m, 0.14 m and 0.18 m are available from the manufacturer.

(a) Choose the most suitable Venturi for the application, assuming a differential pressure at maximum flow of approximately 3 × 105 Pa.

(b) Calculate an accurate value for the differential pressure developed across the chosen Venturi, at maximum flow rate. (Use the following formula for the coefficient of discharge:

where

d = Venturi throat diameter, and ReD = Reynolds number referred to pipe diameter.)

 

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….