Analyse and report your findings with regards the organisations preparedness for change or the major changes that will impact the organisation and should be systematically managed under a change project.

Description and requirements

1.Useoneof the tools provided in theChange Leaders Toolboxto audit or survey an organisation. The audit should report on one of the following:

a.Tool 2PEST(LE) analysis

b.Tool 3SWOT analysis

c.Tool 4Cultural capital & maturity assessment tool

d.Tool 5Change readiness audit tool

e.Tool 6Organisational maturity scorecard

f.Tool 7Mapping leadership methods to change audit results

g.A tool you source and have approved by your lecturer. [10 marks]

 

2.Analyse and report your findings with regards the organisations preparedness for change or the major changes that will impact the organisation and should be systematically managed under a change project. Be sure to make insights and observations based on the literature provided with this unit and well-grounded academic research you have conducted in support of your findings. [10 marks]

 

This may be based on a case study or organisational profile you have accessed, your own organisation or one with which you can gain sufficient permission to access, or a study your lecturer may provide if you cannot satisfy the other options.

find the cost of your paper

Sketch the load characteristics, terminal voltage/load current, of the following types of DC generator

1. (a) Sketch the load characteristics, terminal voltage/load current, of the following types of DC generator: (i) series-connected, (ii) shunt-connected and (iii) compound-connected.   (b) State one purpose for which….

what happens if the resistance in series with the shunt field of a DC motor is increased in value

1. Sparking at the trailing edges of the brushes in a DC machine is usually prevented by fitting   (a) copper gauze brushes (b) a compensating winding (c) a compound….

Calculate the synchronous speed of a 10-pole three-phase machine connected to a 50 Hz supply.

1. The generator characteristic shown in Figure 9.28 is for a   (a) shunt machine (b) series machine (c) differentially compounded machine (d) cumulatively compounded machine 2.The speed of a….